|
|
Joined:
March 2007
Posts: 698
Location: Cork, Ireland | Any suggestions for materials to make a case for lap steel? Internal dimensions about 34" x 4" x 4". Would 14" ply be OK in terms of strength/weight ? |
|
| |
|
Joined:
March 2007
Posts: 698
Location: Cork, Ireland | Just saw Seesquares post !!! Definitely gonna steal the amp in case idea. |
|
| |
|
Joined:
November 2002
Posts: 3599
Location: Pacific Northwest Inland Empire | Yeah, the parts were cheap, really. It was all the design & hand work that tested my meddle. Got the electronics from China (FleaBay), the 1/4" ply from Home Depot, the vinyl fabric from Hancock Fabrics, the latches & hinges from Shanghai (FleaBay), foam & spray glue from Fred Meyer (local grocery/department superstore). About 30 man-hours later, "independent" amplification. |
|
| |
|
Joined:
March 2007
Posts: 698
Location: Cork, Ireland | are the sides plywood too? |
|
| |
|
Joined:
November 2002
Posts: 3599
Location: Pacific Northwest Inland Empire | Yep. It's a 5-1/2x9x36-inch plywood box, covered with a vinyl fabric. The covers, over the speaker coils, are of the same plywood panel. I used 3/8-inch square wood stock, as the bolsters for the wood joints. Not likely to come apart, anytime soon. |
|
| |
Building a case
