|
|
Joined:
February 2004
Posts: 1634
Location: Warren,Pa. | Things are going well. The hole for the preamp is PERFECT! All it took was patience...and a cordless dremel...and a little skill...and nerve.
I'm working on the dual output now. I have the 2 holes drilled for the jacks. Now I have to figure out how to find the placement of the 2 little screw holes. This may be a no-brainer for some of you, but I can't figure out how to do it. HELP please.
John <>{ |
|
| |
|
Joined:
February 2005
Posts: 11840
Location: closely held secret | Congrats, John!
I got my initial marks for placement by holding it up to the holes on the inside and eyeballing the position relative to the hole, then I measured off the center of the XLR jack for the actual distance to where the screws go. Does that make any sense? |
|
| |
|
Joined:
February 2004
Posts: 1634
Location: Warren,Pa. | It's hard to eyeball much. This is such a little guitar to work on.
But my wife just came home; she's the analytical/mathematical person in the home. I'll see if I can "give" this little problem to her. |
|
| |
|
Joined:
January 2004
Posts: 799
Location: Athens, GA & Gnashville | I really admire you guys that can do this type of work. I don't have the nerve...much less the tools for it. |
|
| |
|
Joined:
October 2005
Posts: 5332
Location: Bluffton, SC | Take some paper and trace the dimensions/placements of the preamp screw holes, then transfer to the bowl but remember to consider any bowl rounding. Good luck! |
|
| |
|
Joined:
August 2006
Posts: 2804
Location: ranson,wva | john,rember that the xlr & 1/4 are at a slight angle from one another.....if i can find my calipers ill measure the distance from center of the screw hole to the center of the 1/4 and that should give the corect placement...ill run out ot the shop and look for my calipers jason |
|
| |
'97 update...need a little help
