|
|
Joined: January 2011 Posts: 344
Location: Italia, Zianigo di Mirano (Venezia) | Hi, my OP-PRO-STUDIO has the LED always on (red).The battery is new.What's the problem?
Edited by titti191730cm 2013-09-29 6:16 AM
|
|
|
|
Joined: August 2011 Posts: 887
Location: Always beautiful canyon country of Utah | Did you check the the battery with a voltmeter to ascertain that it is indeed good?? |
|
|
|
Joined: January 2011 Posts: 344
Location: Italia, Zianigo di Mirano (Venezia) | I tried several batteries .... |
|
|
|
Joined: March 2008 Posts: 2683
Location: Hot Springs, S.D. | Duct tape. No, make that electrical tape. If everything is working, just put a little electrical tape over the light so you can't see it. It's black so it won't even show. That's what the car guys always do... |
|
|
|
Joined: October 2005 Posts: 4044
Location: Utah | That's what my OpPro Studio did just before it died. I may have damaged it by plugging into phantom power, but I am not sure. I hope yours is not dying. If you purchased it in a new guitar it should be covered by warranty. |
|
|
|
Joined: April 2010 Posts: 823
Location: sitting at my computer | I looked here... http://www.ovationguitars.com/electronics/product/op_pro_studio_with_xlr but, unfortunately it doesn't mention anything about when the light stays on continuously. 8. BATT. LOW: The LED performs several functions. First, when an appropriate plug is inserted into the guitar’s output jack, this LED will briefly glow red to indicate power-up. Second, the LED will flash red when the battery is reaching the end of its useful life. |
|
|
|
Joined: January 2011 Posts: 344
Location: Italia, Zianigo di Mirano (Venezia) | a few days ago, I tried for the first time a cable cannon in Phantom alimentation.Non worked, no sound.Then he turned on the red led.I am attaching pictures of the can ,front-rear .It should support XRL outpout Phantom alimentation (48volt) ....
|
|
|