|
|
Joined:
March 2007
Posts: 698
Location: Cork, Ireland | I've borrowed a set of nut files to do a bit of work on a mandolin (and maybe a few guitars while I'm at it).
the thinnest file is 0.015" whereas the e strings on the mando are 0.011". WIll this file make the slot too wide? The nut is not bad as it is but I want to lower the slots just a fraction to make it just right. |
|
| |
|
Joined:
November 2002
Posts: 3611
Location: Pacific Northwest Inland Empire | Check out these welding tip files. Might be what you're needin'......
http://www.ebay.com/itm/NEW-Welding-Tip-Cleaner-Carb-Jetting-tool-p... |
|
| |
|
Joined:
June 2012
Posts: 2316
Location: Pueblo West, CO | I usually try to keep the slots as close to the string width as possible.
If it were mine, I wouldn't use a .015" for a .011" string. |
|
| |
Nut Files
