|
| Random quote: "One good thing about music, when it hits you, you feel no pain." - Bob Marley |
 Saddles
| View previous thread :: View next thread | |
| Members Forums -> General Posting | Message format | |
TAFKAR |
| ||
Joined: April 2008 Posts: 2985 Location: Sydney, Australia | |||
| |||
| Old Man Arthur |
| ||
Joined: September 2006 Posts: 10777 Location: Keepin' It Weird in Portland, OR | I found some old photos that I had on Photobucket that may help. Basically, the actual saddle just "clips-on" to the metal "frame" that is underneath the pick-up. These photos are of an old, broken, pickup that I sent off to a member (I don't remember who).  This is the saddle out of the pickup, and on this you can see the underside of the saddle where the original pickup was fried.  On this end view you can see how the metal base-frame has a bent-over lip on the edge that goes over the edge of the plastic saddle. You can also see the curved edge in the photo above.  And here is a photo showing the putty-rubbery-stuff that is under the saddle. The piezo elements are in there somewhere.  The tools that are lying around are the precision screwdriver that I used to pry it apart. I say "pry" but it isn't that difficult to get it apart. When you take the whole pickup unit out of the guitar, you can remove the black end-pieces from the pickup assembly. The black pieces remove by lifting them straight "up". There should be two pins sticking through the metal frame... If you push on them from the bottom the black thing will come "UP".  Once you take that end piece off it would be easier to remove the old saddle. Once you have removed the old saddle it is easier to understand how the new one goes back in. I am not sure if it matters which way you put the saddle back in, but match them up to your old saddle. I can see that both "E" saddles are off-set, but it might matter which way it goes in. Hope that helps.  | ||
| |||
| TAFKAR |
| ||
Joined: April 2008 Posts: 2985 Location: Sydney, Australia | |||
| |||
| TAFKAR |
| ||
Joined: April 2008 Posts: 2985 Location: Sydney, Australia | And here's the final product | ||
| |||
| Old Man Arthur |
| ||
Joined: September 2006 Posts: 10777 Location: Keepin' It Weird in Portland, OR | Man... I want one of them. "Detroit Bob" in the Welcome Center caused me to dig-out my 1681. Now you just inspired me to grab it again. | ||
| |||
| DanSavage |
| ||
Joined: June 2012 Posts: 2333 Location: Pueblo West, CO | |||
| |||
| muzza |
| ||
 Joined: August 2005 Posts: 3736 Location: Sunshine State, Australia | |||
| |||
| TAFKAR |
| ||
Joined: April 2008 Posts: 2985 Location: Sydney, Australia | |||
| |||
| Jump to page : 1 Now viewing page 1 [25 messages per page] |
| Search this forum Printer friendly version E-mail a link to this thread |
| This message board and website is not sponsored or affiliated with Ovation® Guitars in any way. | |
| (Delete all cookies set by this site) | |