|
|
Joined:
November 2004
Posts: 1374
| for wood solid body Ovations...
need to trade for neckplate for UKII
or do I just have to bevel/grind the back edges off this one?
thanks,
Glenn |
|
| |
|
Joined:
August 2006
Posts: 3145
Location: Marlton, NJ | Glenn - can you post, or send me a list of what you have to trade?
Thanks,
Mike |
|
| |
|
Joined:
November 2004
Posts: 1374
| 1 set of ovation bridge studs, for old brass/plastic bridge
1 chrome Ovation neckplate for viper/preacher etc..
4 long shaft 500 k cts pots and 2 orange drops
2 long shaft tall cts 3 way switches
Glenn |
|
| |
|
Joined:
August 2006
Posts: 3145
Location: Marlton, NJ | Glenn - are you looking for a gold neck plate for the UKII? Is it the same as a preacher/viper neckplate? |
|
| |
|
Joined:
November 2004
Posts: 1374
| yes.. for a uk.. I believe the first batches of neckplates were smaller to fit the recess in the body... I think they later just ground the back edges off the standard plates so they would fit later on.. at least I've had two that looked that way.
a gold one would be great. and if it's a uk or already ground down better.
but if not I can probably not butcher the one I have too badly on a grinder.
Glenn |
|
| |
|
Joined:
August 2006
Posts: 3145
Location: Marlton, NJ | Just when I think I know enough - another little factoid pops up! |
|
| |
|
Joined:
December 2003
Posts: 13996
Location: Upper Left USA | Do you have a template or some measurements?
 |
|
| |
want to trade ovation chrome neckplate