|
|
Joined:
February 2004
Posts: 1634
Location: Warren,Pa. | When Ovation finished this run of guitars, they had a bunch of small bowls left over. Those bowls were made into at least one, maybe two, lesser quality parlor-sized guitars. These were Celebrity-level guitars if I remember correctly.
So I have to believe they didn't use the top-of-the-line TKL case that was provided with the '97 Collectors'. Does anyone know for sure if any different cases exist for this guitar? My '97 would make a great travel guitar (in safe places only) if it had a smaller, LIGHTER case/gig bag. Any answers from the experts?
John <>{ |
|
| |
|
Joined:
December 2003
Posts: 1071
Location: Carle Place, NY | Levys makes very sturdy gig bags for the Taylor Baby. Here\'s one on eBay for $23 with shipping.
The dimensions of the Baby Taylor are:
Body width-12 1/2"
Body depth-3 3/8"
Body length- 15 3/4"
Overall length-33 3/4"
Check the measurements of your '97. It might be a good fit.
There's also the Big Baby Gig Bag
Big Baby measurements are:
Width-15"
Depth-4"
Body length- 19 1/2"
Overall length- 40 1/4" |
|
| |
|
Joined:
February 2004
Posts: 1634
Location: Warren,Pa. | I happen to have both a Baby and my '97 on my kitchen table at the moment...not even close. I've had lots of alternate suggestions in the past and I firmly believe there is no case out there that fits this guitar except one that was made specifically for it. |
|
| |
|
Joined:
February 2004
Posts: 1634
Location: Warren,Pa. | I happen to have both a Baby and my '97 on my kitchen table at the moment...not even close. I've had lots of alternate suggestions in the past and I firmly believe there is no case out there that fits this guitar except one that was made specifically for it. |
|
| |
|
Joined:
February 2004
Posts: 1634
Location: Warren,Pa. | ...and again I say!!!... |
|
| |
|
Joined:
December 2003
Posts: 1071
Location: Carle Place, NY | What about something like this? |
|
| |
|
Joined:
April 2006
Posts: 972
Location: PDX | I know this is the obvious, but just in case; have you talked to the folks at Ovation to see if they have one?
_____
gh1 |
|
| |
|
Joined:
April 2003
Posts: 557
Location: Burbank | The guitar they made with the left over bowls was the 5741. It is a parlor size body with a regular 14 fret standard peghead neck, with an OP-24E pre-amp. They used the same case without the '97 collectors plate. I saw one and was told this by the factory. |
|
| |
|
Joined:
February 2004
Posts: 1634
Location: Warren,Pa. | Well, I'll consider that the definitive statement. I sent Master Templeman a private email asking him if it would fit. I really like that gig bag. Thanks for the feedback everyone. John <>{ |
|
| |
Still looking: Case for '97 Collectors'